Allied fire barrier panels and boards show the highest compressive and bending strengths versus autoclaved and cast-in-place foam cement products, all measured at 35 pcf.
| Cement Composite | Cure Condition | Density | Compressive Strength | Bending Strength |
|---|---|---|---|---|
| AFT Fire Barrier Foam I | Room temp. | 35 pcf | 900 – 1,000 psi | 370 – 500 psi |
| AFT Fire Barrier Foam II | Room temp. | 35 pcf | 650 – 750 psi | 300 – 350 psi |
| AFT Portland Cem I/II | Room temp. | 35 pcf | 400 – 450 psi | 100 – 200 psi |
| Autoclaved Concrete | Autoclaving | 35 pcf | 600 – 700 psi | ~100 psi |
Values as published by Allied Foam Tech. Fire Barrier Foam I leads both compressive and bending strength at equal density.
Fire rated and easy to handle, ready for precast or cast-in-place manufacture — with good adhesion to steel, non-hazardous, no rust, and solvent-free.
Fire rated, easy to handle, suited to precast or cast-in-place manufacture.
Higher-density panel with the same fire-rated, easy-handling build.
Sprayable with good adhesion to steel — non-hazardous, no rust, solvent-free.
Vertical spray with strong adhesion — non-hazardous, no rust, solvent-free.
For buildings taller than 420 feet (128 m) per SFRM — Spray-applied Fire Resistant Material.
All foam products are supplied in concentrated form, available in 55-gallon drums or totes. Foam generators output from a few liters to hundreds of liters per minute.
90 pcf down to 3 pcf for geotechnical engineering, landscape architecture, roof decks, panels, partitions, blocks, and cinder-block inserts.
Open and closed-pore structure similar to urethane and polystyrene foams — without their poor fire resistance, and with outdoor durability and cost advantage.
Strength and thermal-shock resistance for durable firebricks used as high-performance insulation in kilns and incinerators.
Flexible, under 1.5 pcf, reaching R > 3.8 per inch with strong fire resistance.
Specially formulated foam used as a long-duration firefighting barrier for the containment of forest fires.
Controlled film thickness with improved resin distribution; foamed adhesives reduce consumption and prevent absorption by porous substrates.
From geotechnical stabilization at the World Trade Center to green-roof fill at Harvard, Allied's foam cement performs where it counts.
A versatile, compact foam cement mixing & pumping setup — high mobility with strong output — placed lightweight geotechnical fill around the 9/11 Memorial Museum and subway structures.
The world's first low-slump geotechnical roof fill used Allied's cement composite design, foam products, and machinery. The award-winning, 530,000 ft² facility places more than half its floor area below grade and incorporates three functioning green roofs, with skylights bringing daylight underground.
For "Wood-like Flexible Cementitious Foam," joining a roster of winners that includes Apple, 3M, and Boeing.
Recognized as the best chemical machinery & equipment manufacturer in Montgomeryville, PA (2009–2011, 2013, 2014, 2015).
Introduced the first high-performance foam cement / lightweight cement grout for floor underlayment.
Fee-based service contracts cover technical assistance, personnel training, and adapting your existing production facilities. Products ship domestically and internationally by surface, ocean, or air freight.